Afterthe settings are done on the computer, we need to do some setting on our Router. Wake up a PC on LAN side. 1. Check MAC address and IP address of the computer need Wake-on-LAN. We call it PC 1 here. 2. Set IP&MAC binding of PC 1 on our router. Classic Web UI. New Web UI. 3. Set Address reservation for PC 1 on our router. Classic Web UI Submenu: /tool wol. The Wake on LAN tool can send a specific frame (Magic Packet) to any MAC address of your choosing. If the target device supports Wake on LAN, it should wake up from sleep or shutdown state. Currently secure WoL is not supported. There are specific hardware and software requirements of the target computer for the Wake on LAN WakeOn LAN is a free application released under the GPLv3 license on Windows from network software. With software released under the open source GPLv3 license, anybody can download, install, run and distribute the software with little in terms of restrictions. The latest version we have is 2.12.4 and is available to download here. Startwith Step 4 to turn off Startup freeloaders which can conflict and cause issues, then Step 7 to check for infection the most thorough way, then step 10 to check for damaged System Files, and also Step 16 to test a new Local Admin account to replace yours which may be corrupted. Chapter1: got it to work! Getting WoWLAN to work wasn't particularly hard, it basically boiled down to two things: Make sure the BIOS would allow it. Configure the wireless NIC settings in Windows. The first step was about looking for the appropriate settings in my BIOS, and setting them to the correct values. Openthe Network Card's hardware settings and, under Adavanced: Make sure Speed&Duplex is set to Auto Negotiation. Enable Wake on Magic Packet. Go to the NIC's Power Management tab and select Allow this device to wake the computer. In Windows 10, go to the Power Options under Control Panel. VRTbzP.

cara setting wake on lan windows 10